Bulldog Security DELUXE 200B, Installation Manual

Page: 15 / 32

15 50
VATS
PASSLOCK I
Remove the Lower Steering Column cover on the
Steering Column.
Locate the (3)Three small 20 Gauge wires (YEL-
LOW, BLACK and WHITE wires in a GRAY or
BLACK Plug) coming out of the Ignition Key Cyl-
inder on the Bottom right hand side of the Steering
Column.
1.
2.
WIRING CONNECTIONS
H2: 5-PIN WIRE HARNESS:
H2/1 – RED/WHITE wire – Parking Light Relay Power Input –
The RED/WHITE wire is the input to the flashing parking light relay.
The connection of the RED/WHITE wire will determine the Output
Polarity on the flashing parking light relay wire WHITE . If the vehicle
you are working on is a (+) Positive Parking Light wire, leave the
RED and RED/WHITE wires connected together and connect these
wires to a (+) 12 Constant source. If your vehicle’s Parking Light
wire is a (-) Negative you will need to cut the RED/WHITE wire from
the RED wire, place the RED wire to a (+) 12 Constant source and
then connect the RED/WHITE wire to a good body Ground .
H2/2 - White wire - Parking Light Relay Output (10A power output)
Connect the WHITE wire to the parking light wire coming from
the headlight switch. Do not connect the WHITE wire to the dash-
board lighting dimmer switch. (Damage to the dimmer will result).
The limitation of the WHITE wire is 10 AMP max . Do not exceed
this limit or damage to the alarm and parking relay will result.
H2/3 - Black wire - System Ground -
This is the main ground connection of the alarm module. Make this
connection to a solid section of the vehicle frame. Do not connect
this wire to any existing ground wires sup lied by the factory wire
loom, make the connection to the vehicle’s frame directly.
H2/4 - Brown wire - (-1 200mA Horn Output -
This wire is provided to use the existing vehicle’s horn as the
keyless entry system’s optional’s warning audible device. It’s a
transistorized low current output, and should only be connected to
the low current ground output from the vehicle’s horn switch.
H2/5 - Red wire - System Power (+12V Constant) -
The RED wire supplies power to the system. Connect this wire to
a constant +12 volt source.
H3: BLACK 4-PIN CONNECTOR. - TWO-WAY TRANSCEIVER/
ANTENNA MODULE
The Two-way transceiver/antenna mounts on the location above the
dashboard of the vehicle for best reception. We suggest you mount it
on the lower left or upper left-hand side of windshield.
Warning! Do not mount in such a manner that it obstructs the driver’s view.
- Remove the protective tape backing.
- Carefully align the two-way transceiver/antenna and apply to windshield.