29
36
PROGRAMMING
START TIMER PROGRAMMING: (TEST and ADJUST)
Press the button twice on the transmitter to start the vehicle.
If everything goes well: Wait for 15 seconds:
If the engine is still running.
Press the button twice on the transmitter to stop the
engine from running. You have completed this program-
ming successfully.
Press button on the transmitter to exit the program
mode. There will be (3) long chirps and (3) parking light
flashes for confirmation.
If the engine shut down after the vehicle was started.
Press the button twice on the transmitter to remotely
turn off the ignition.
Press button on the transmitter to set “Check Level’
to
“LOW”
position. (2) LED flashes, (2) chirps to con
-
form this setting.
Repeat the step l - 2.
If the crank time is too long, (Engine already successfully running,
while starter remains engaged):
Press the button twice on the transmitter to stop the
engine from running.
Press button on the transmitter to set proper “Start
Timer”. The chirp and LED pause will confirm that you have
entered this mode. (Decrease “Start Timer” as necessary.)
Repeat the step l - 4.
If the crank time is too short, (Engine is not running, starter did
not stay engaged long enough):
Press the button twice on the transmitter to stop engine running.
Press button on the transmitter to set proper “Start
Timer”. The chirp and LED pause will confirm this enters.
(Increase “Start Timer” is necessary.)
Repeat the step I-4.
RETURN TO FACTORY DEFAULT SETTING:
Turn the ignition
“ON”
then
“OFF” (3) TIMES
and stay in
“OFF”
position.
Push the Program switch (12) times and hold in on the 12th push
until (6) chirps with a long chirp is heard then release the Program
switch. You are now in the “Return To Factory Default Setting”
programming mode.
1.
2.
a.
I.
II.
b.
I.
II.
III.
3.
a.
b.
c.
1.
a.
b.
c.
1.
2.
IMPORTANT OWNER’S NOTICE
WARNINGS:
As with any product that performs automatic functions, there are certain
safety precautions that you must practice and be aware of.
Keep the transmitter out of children’s reach.
Do not leave anyone in the vehicle while running on remote control.
Alert servicing personnel that the vehicle can be started automati-
cally.
Do not start the vehicle by remote while it’s in an enclosed area or
garage.
Always apply the parking brake and lock the vehicle as you exit the
vehicle.
The vehicle windows must be rolled up.
Should the unit malfunction, disconnect the fuse until the problem is
corrected.
The use and operations of this system is the sole responsibility of
the operator.
Some areas may have local ordinances that prohibit leaving a ve-
hicle running on public streets.
Do not start the vehicle by remote while the standard transmission
vehicle is parked on a steep road.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Summary of Contents for DELUXE 200B
Page 1: ......
