39
26
PROGRAMMING
FEATURE #III PROGRAMMING
Turn the ignition switch
“ON/OFF” (3) TIMES
and leave in the
“OFF”
position.
Push the Program switch (6) times and hold in on the 6th push
until (3) chirps with a long chirp is heard then release the Program
switch. You are now in the feature
“III”
programming mode.
Press and release the transmitter button that corresponds to the
feature you desire to program.
FEATURE #III PROGRAMMING CHART
Press
Transmitter
Button
One Chirp
with One LED
Pulse Factory
Default
Setting
Two Chirps
with Two LED
Pulses
Three Chirps
with Three
LED Pulses
Four Chirps
with
Four LED
Pulses
1
Gasoline
Engine
N/A
N/A
N/A
2
20 minute
run time
30 minute
run time
5 minute
run time
10 minute
run time
3
Factory
alarm/disarm
with all output
channels
Without this
feature
4
3 Hour Time
Start
2 Hour Time
Start
EXIT: Turn Ignition to “ON” position, or leave it for 15 seconds.
(3) long horn chirps and (3) parking light flashes will confirm
exit.
1.
2.
3.
OPERATION
J. VIBRATION/MELODY MODE:
It is useful when you are in a noisy place. The remote control
in this mode, vibrates it if your security system is triggered.
Press button first, within (5) seconds, press the
button to select the mode of vibration or melody, the
icon will displayed on the LCD screen to show the LCD
remote transceiver is on vibration mode.
To exit programming mode, take no action for (5) seconds. The re-
mote control will generate two long beeps to indicate programming
mode has been exited.
K. SCREEN LAMP ON:
Press the button once; the LCD screen lamp will turns on for (5) seconds.
REMOTE START OPERATION:
NOTE **
If you press the (START) button (2) times and you get no
response from the remote control to the unit, try all other buttons. If you
get no response to the other buttons on the remote control, please see
page 23 and follow the instructions for PROGRAMMING A NEW
TRANSMITTER procedure.
TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
Press button twice on the transmitter
The parking light will activate to indicate the remote start
received the signal. (A melody sounding from your Remote
LCD transceiver and icon will flashes on the LCD screen
to confirm the remote start was activated.)
The engine will start in approximately (5) seconds.
Once the engine is running, after a couple of seconds the
parking light will turn on again and climate controls will ac-
tivate and adjust the vehicles interior temperature to your
preset setting. (While the vehicle is running, the icon
and the “minutes” digit on the LCD screen will flash and it
will indicate count down timer based on the 5, 10, 20 or
30 minute run time set up by your installation center.)
The vehicle will run for 5 to 30 minute cycle and automati-
cally shut down. (When the unit shuts off, the count down
timer will turn off and the transmitter will play a melody.)
1.
2.
1.
2.
3.
4.
5.
Active
Remote
Start
Engine
Running
Summary of Contents for DELUXE 200B
Page 1: ......
