23
42
WIRING CONNECTIONS
H6/2-PIN BLUE CONNECTOR FOR THE PROGRAM SWITCH
Select a mounting location for the switch that is easily accessible to the
driver of the vehicle. The switch does not have to be concealed, how-
ever, concealing the switch is always recommended. Route the program
switch wires to the control module.
PROGRAMMING
A. PROGRAMMING A NEW TRANSMITTER:
Before doing any Programming, make sure the Module is in UNLOCK
Mode, even if you choose not to connect up the Keyless Entry sec-
tion of this unit. To program, the unit must be in UNLOCK Mode or the
programming will not take.
Your two-way remote transmitter may need to be programmed to
the transceiver when you first install the unit. Please confirm that the
antenna transceiver is plugged into the control module before pro-
gramming is attempted. Note: The control module will only retain the
last 4 remote transmitters programmed. I f the transmitter memory
is exceeded, the security system will start deleting transmitters from
memory in chronological order.
Turn the Ignition switch from ‘OFF” to “ON” [3) times and leave in
the ‘ON” position.
Within 15 seconds, push the valet/program switch (3) times
and on the 3rd push hold it in until a long chirp from horn then
release the valet/program switch. You are now in the transmitter
programming mode.
Press and hold any button on the transmitter until (1) chirp from
the horn and (1) flash from the parking lights confirming the first
transmitter is now programmed.
If you have additional transmitters (up to 4) that need to be pro-
grammed, repeat step 3 for each transmitter.
B. FEATURES PROGRAMMING:
Before doing any Programming, make sure the Module is in UNLOCK
Mode, even if you choose not to connect up the Keyless Entry sec-
tion of this unit. To program, the unit must be in UNLOCK Mode or the
programming will not take.
1.
2.
3.
4.
OPERATION
G. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system’s remote start unit to be temporarily dis-
abled to prevent the vehicle from being remote started accidentally. This
feature is useful if the vehicle is being serviced or stored in an enclosed
area. To disable the remote start, move the optional remote start enable
toggle switch to the OFF position.
LCD REMOTE TRANSCEIVER
Note:
If the system is interfered with stronger radio frequency around,
sources of high voltage electric power or such or if there are obstacles
like tall buildings and so on, the transmission range may get shorter as
the system uses low out put power.
BATTERY REPLACEMENT:
A 1.5V type AAA Alkaline battery powers the Remote Transceiver. When
the battery weakens a icon shall be displayed on the LCD screen.
Summary of Contents for DELUXE 200B
Page 1: ......
