17
48
VATS
Measure the resistance of the little Pellet on the
Ignition Key. It should be between
392 Ohms and
11,800 Ohms
. To do this, put the Ohm Meter probes
on each side of the Key Pellet. The Resistance value
should be close to one of the following (all values in
Ohms):
392, 523, 681, 887, 1.13K, 1.87K, 3.01K,
3.74K, 4.75K, 6.04K, 7.50K, 9.53K, 11.8K.
Locate the closest value that is less than your
desired value.
Set Dip Switches 2 through 6
to
match the chart on Page 47.
Put your
Ohm Meter (multi-meter)
probes on
the
(2)Two Silver Resistance Measuring Pads
through the opening shown in the drawing – mak-
ing good contact with these (2)Two Silver Resistance
Measuring Pads on the board. (See drawing on page
1). Or put your (2)Two
Ohm Meter
(multi-meter)
probes into the
(2)Two holes
on the bottom of the
case making contact with the underside of the
Silver
Pads
. Either contact point method will work.
With the probes held firmly – dial-in the final resis
-
tance value needed for your system by turning the
screw on the variable resistor on the side of the unit
next to the Dip Switches. Turn the screw unit the
resistance value matches the resistance value of the
Pellet on the Key.
Locate the pair of
VATS wires
sometimes
(2)
1.
2.
3.
4.
5.
WIRING CONNECTIONS
H4/2 - Thin Black wire - (-) Neutral Safety Switch or (-)
Remote Toggle Switch Input -
When the THIN BLACK wire is grounded, the remote start unit is oper-
able. When this wire is open from ground, the remote start is disabled.
The optional “remote start toggle switch” can be added on to
temporarily disable the Remote Start Device, it can prevent
the vehicle from being remote started accidentally. This fea-
ture is useful if the vehicle is being serviced or stored in an
enclosed area. To disable the remote start, move the remote
start enable toggle switch to the ‘OFF” position. To enable the
remote start, move the optional remote start enable toggle
switch to the “ON” position.
If needed, this wire will connect to the PARK/NEUTRAL switch
in the vehicle. (See the TESTING YOUR INSTALLATION GUIDE)
IMPORTANT NOTE: Directly connect the THIN BLACK wire to the
‘GROUND” when this wire is not used.
H4/3 - Brown / Red wire - (+) Positive Safety Shut Down For Brake
This wire ~provides an instant shutdown
for the remote start, whenever it receives
+12 volts
. If the brake lights switch in the
vehicle switches
+12 volts
to the brake
light connect this wire to the output side
of the brake switch. This will allow the
remote start to shut down if an attempt is
made to operate the vehicle without the key while running under the
control of the remote start. In most vehicles, in order to shift gear, the
brake pedal must be pressed. The brake input will in turn cause the
remote start unit to shut off. (See diagram.)
H4/4 - Grey wire - (-) Negative Safety Shut Down For Hood Pin
Switch
This wire provides an instant shutdown for the remote start, when-
ever it is grounded. Connect the wire to the hood pin switch previ-
ously installed. This wire must be routed through a grommet in the
firewall and connected to the hood pin switch.
1.
2.
Summary of Contents for DELUXE 200B
Page 1: ......
