Design and function
Verti-Mix 951-1651, Verti-Mix 951 L-1251 L, Verti-Mix 1501 D-2401 D 10.13
89
5.12.2.1 Connect hydraulic hose pipes
WARNING
Risk of being crushed, cut, becoming entangled, being drawn in
and risk of impact to people due to malfunctions caused by
improperly connected hydraulic hose pipes!
Check the assignment of the hydraulic hose pipes at the control
block of the machine if the coloured markings (dust caps) are
missing:
P = Pressure line
T (R;S) = Return line
Check the compatibility of the hydraulic oils before connecting
the machine to the hydraulic system of your tractor.
Do not mix mineral oils with bio oils!
Observe the maximum admissible operating pressure of the
hydraulic oil. For details refer to the chapter "Required tractor
equipment", page 27.
Only connect clean hydraulic plugs and hydraulic sleeves.
Slip the hydraulic plug into the hydraulic sleeve until the
hydraulic plug noticeably locks.
Check the coupling spots of the hydraulic hose pipes for correct
and tight seat.
Connected hydraulic hose pipes:
must easily give way to any movements during cornering
without any stress, buckling or chafing,
must not chafe against external components.
Dru
1. Swivel the respective operating element at the control device on the tractor to open-centre
position (neutral position).
2. Connect the hydraulic hose pipes to the control devices of the tractor:
2.1 Pressure pipe to a single-acting or double-acting control device.
2.2 Return pipe to a depressurized return port if possible.
5.12.2.2 Disconnect hydraulic hose pipes
Dru
1. Swivel the respective operating element at the control device on the tractor to open-centre
position (neutral position).
2. Unlock the hydraulic plugs from the hydraulic sleeves.
3. Use the dust caps to protect the hydraulic plugs and the hydraulic sleeves against soiling.
4. Put the hydraulic hose pipes down onto the hose holder.
