Design and function
62
Verti-Mix 951-1651, Verti-Mix 951 L-1251 L, Verti-Mix 1501 D-2401 D 10.13
5.3.1
Mount holder with pocket for mechanical and electrical remote control set
1. Fix the holder (1) with the pocket (2) for the
mechanical remote control set at an
appropriate place in the tractor's cabin.
2. Insert the mechanical remote control set
into the pocket (2).
Fig. 35
5.4
Change gear level by means of switchgear
The switchgear is not synchronised. Changing gear level is only
possible when the vehicle is stationary or when it is coasting or
starting at low speed.
Different steps may therefore be necessary for changing gear level by
means of the switchgear. The necessary steps depend on:
the type of actuation of the tractor’s p.t.o. shaft:
after the p.t.o. shaft has been switched off, the p.t.o. shaft
drive of the tractor is slowed down during coasting and
when stationary,
the p.t.o shaft coupling engages very fast when the p.t.o.
shaft is switched on.
the type of remote control of the switchgear:
mechanical remote control via Bowden cable,
electrical remote control via the control set.
the amount of load of the mixing auger in the mixing container:
empty or slightly filled mixing container,
fully filled mixing container.
Hereinafter, two different procedures for changing gear level by
means of the switchgear are described.
Empty or slightly filled mixing container – low amount of load of mixing auger
1. Switch the tractor's p.t.o. shaft off.
2. Use the switchgear to change the gear level via the mechanical / electrical remote control set.
3. Switch the p.t.o. shaft of the tractor on again.
During restarting, changing gear level is initiated in the switchgear.
