Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
341
53-1002373-02
Managing interface modules
7
Specifying an immediate boot from the auxiliary flash slots on the management module
To specify an immediate boot for the interface module installed in slot 1 from the auxiliary flash slot
on the management module, enter the lp boot system command at the Privileged EXEC level of the
CLI.
Brocade# lp boot system slot1 primary 1
Syntax: lp boot system slot1 | slot2 <
filename
> <
slot-number
>
•
The slot1 and slot2 keywords indicate the auxiliary flash slot on the management module from
which to boot the interface module.
•
The
<filename>
parameter specifies the name of the image from which to boot the interface
module.
•
The
<slot-number>
parameter specifies the device slot number that contains the interface
module that will undergo an immediate boot. You can specify 1 – 4 for 4-slot devices, 1 – 8 for
8-slot devices, 1 – 16 for 16-slot devices, or 1 – 32 for 32-slot devices.
Specifying an immediate boot from management module flash memory
To specify an immediate boot from the primary image on the management module for the interface
module installed in slot 1, enter the following command at the Privileged EXEC level of the CLI.
Brocade# lp boot system mp primary 1
Syntax: lp boot system mp primary | secondary
<slot-number>
•
The primary and secondary keywords specify the primary or secondary software image in flash
memory on the management module.
•
The
<slot-number>
parameter specifies the device slot number that contains the interface
module that will undergo an immediate boot.You can specify 1 – 4 for 4-slot devices, 1 – 8 for
8-slot devices, 1 – 16 for 16-slot devices, or 1 – 32 for 32-slot devices.
Specifying an immediate boot from flash memory on the interface module
To specify an immediate boot from the primary image in flash memory on the interface module
installed in slot 1, enter the following command at the Privileged EXEC level of the CLI.
Brocade# lp boot system flash primary 1
Syntax: lp boot system flash [primary | secondary]
<slot-number>
•
The primary and secondary keywords specify the primary or secondary image in the interface
module flash memory.
•
The
<slot-number>
parameter specifies the slot number that contains the interface module
that will undergo an immediate boot.You can specify 1 – 4 for 4-slot devices, 1 – 8 for 8-slot
devices, 1 – 16 for 16-slot devices, or 1 – 32 for 32-slot devices.
Specifying an immediate boot from a TFTP server
To specify an immediate boot for the interface module installed in slot 1 from a TFTP server, enter
the following command at the Privileged EXEC level of the CLI.
Brocade# lp boot system tftp 123.123.123.123 primary 1
Syntax: lp boot system tftp
<ip-address> <filename> <slot-number>
•
The
<ip-address>
parameter specifies the IP address of the TFTP server from which the
interface module will be booted.
