Brandt GRAIN VAC 5000, Operator And Parts Manual

Page: 17 / 104

16
4
5
2.8 Safety Decal Locations
The following illustration shows the position and content of the various safety decals on the Brandt Grain
Vac 5000. If safety decals ever become damaged, removed or illegible, new decals must be applied.
New decals are available from your authorized dealer.
1
2
3
D
ECAL
L
OCATIONS
MOVING PART HAZARD
To prevent serious injury or death from moving parts:
• KEEP AWAY, Moving parts can crush and
dismember.
• Do not operate without guards and shields in place.
• Close and secure guards and shields before
starting.
• Keep hands, feet, hair and clothing away from
moving parts.
• Disconnect and lockout power source before
adjusting or servicing.
• Do not stand or climb on machine when operating.
B029111
DANGER
1. Read and understand the operator’s manual before operating.
2. Keep all safety shields and devises in place.
3. Make certain everyone is clear before operating or moving
the machine.
4. Keep hands, feet and clothing away from all moving parts.
5. Shut off power to adjust, service or clean the auger.
6. Support discharge end or anchor intake to prevent upending.
(See Operator’s Manual)
7. Disconnect power before resetting motor overload. (electric
Motor Drive)
8. Empty auger before moving to prevent upending.
9. Lower auger to transport position before moving or
transporting.
10. Make certain electric motors are grounded.
11. Use only genuine Brandt replacement parts, especially
shearpins and bolts.
12. Do not run this auger empty except at idling speed.
B029010
CAUTION
DANGER
ELECTROCUTION HAZARD
To prevent serious injury or death from
electrocution:
• Stay away from overhead power
lines when transporting or raising
wings.
This machine is not grounded.
Electrocution can occur without direct
contact.
B029050
DANGER
PTO SPEED - 1000 RPM
KEEP ALL SAFETY
SHIELDS IN PLACE
FAILURE TO DO SO WILL
RESULT IN SERIOUS
INJURY OR DEATH
B029175
CAUTION
HEARING PROTECTION
REQUIRED HERE
2
3
4
5
6
7
8
9
10
1