FXS Gateway Overview
- 90 -
(0: OFF, 1: Client(Subscribe),2: Proxy(NOTIFY))
-mwiexpires MWI Subscription Keep Alive for Client(default:1800 sec)
-mwinumber Voice MailBox Number
-autosiport SIP port assigning manner(0:Disable/1:Enable)
-waiting Enable the Call Waiting function(0:OFF 1: ON )
Example:
sysconf -keypad 0 -eod 2 -callerid 1
usr/config$
Figure 21-26 sysconf command list
Parameter Usages:
-print: Print current sysconf settings.
-idtime: Set the duration (in second) of two pressed digits in dial mode as timed out. If
after the duration user hasn’t pressed next number, it will dial out all number
pressed (1-10 seconds).
-service: set SIP Phone to be normal mode or under hotline mode. (sysconf –service
0/1, 0 for normal service, 1 for hotline service.)
-bf: Only working in Proxy mode and Peer-to-Peer mode (some previous version does
not support in Peer-to-Peer mode). If the line1 is engaged as well as this
function is enabled, the line2 will be ringing.
-keypad: DTMF replay type. When value is “1”, FXS Gateway will transfer DTMF
signal via RTP payload as defined in RFC2833. When the value is set to “0”,
the DTMF type is set as In-band, and set 2 for SIP info method.
-faxtype: FAX Payload Type. Rrange:96~128 inter-used:100,102~105.
-2833type: RFC2833 Payload Type. Range: 96~128 inter-used: 100, 102~105.
-lcdrop: Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0).
-droptime: Period of Loop Current Drop (ms).
-eod: It will transfer the DTMF in [#] if users disable the end of dial function. Users
have to press the keypad in [#] if the end of dial function is enabled.
-callerid: Support Bell Core and DTMF callerID function. After the first ring at
destination site, device will send line number as callerID to called site.
-dtmfstart: DTMF CallerID Start Symbol.
-dtmfstart: DTMF CallerID End Symbol.
-userphone: The user=phone is a SIP parameter; it indicates that this is phone call.
Some endpoint does not recognize this parameter, so 350x provide this
command to disable this parameter.
