High-speed Positioning System
Installing the High Speed Positioning System | en
21
Bosch Security Systems, Inc.
Installation Manual
F.01U.164.491 | 2.0 | 2010.03
4.1.1
Wiring the Device
Figure 4.4
Preparing the Cables for Wiring
1.
Cut the cables to approximately 152.4 mm (6 in.) (see
Figure 4.4
). The earth cable must
be longer then the power wires by approximately 10 mm or more to prevent
disconnection.
2.
Cover the power cable with the plastic tube provided and fix it with the tie thread.
3.
Make a group with all signal cables and fix them with the tie thread. See the illustration
below for a proper cable connection; note: IR360 version board will vary slightly due to
the signals connector having 16 lines as compared to 19 as shown below.
Figure 4.5
Tie Threads used to Group and Secure Cables
