18
en | Installing the High Speed Positioning System
High-speed Positioning System
F.01U.164.491 | 2.0 | 2010.03
Installation Manual
Bosch Security Systems, Inc.
4
Installing the High Speed Positioning System
This chapter outlines the procedures needed to mount the High Speed Positioning System.
Installation should be done only by qualified service personnel in conformance to all local
codes.
4.1
Mounting the High Speed Positioning System
The High Speed Positioning System can be mounted with either a wall mount (MTC-WUPH,
sold separately) or a pole mount (MTC-PUPH, sold separately).
To install the device, proceed as follows:
1.
Determine the location to install the device.
–
When selecting a location, a minimum clearance of 300 mm (12 in.) in front of the
unit and 300 mm (12 in.) in back of the unit is required to facilitate component
removal and installation.
–
The device should be installed vertically. Any other position could impair the
performance of the device.
–
Do not attach the device upside down.
2.
Insert the cables into the optional wall or pole mount so they protrude approximately
0.5 m (19.7 in.).
Figure 4.1
Optional Wall Mount (1) or Pole Mount (2)
NOTICE!
The High-speed Positioning System unit cannot be mounted upside down! This configuration
stresses bearings and mechanical components; no liabilities are accepted and all warranties
are void.
NOTICE!
In accordance with NEC laws, you may be required to install an external power junction box.
1
1
2
2
.5 m
19.7 in.
.5 m
19.7 in.
MTC-WUPH
MTC-PUPH
WARNING!
The cables should not be accessible by unauthorized personnel; cables should be secured to
fixed locations at appropriate intervals to bare the weight of the cables, for example, cables
running inside a tall camera pole.
