High-speed Positioning System
Keyboard Commands List - Bosch | en
59
Bosch Security Systems, Inc.
Installation Manual
F.01U.164.491 | 2.0 | 2010.03
Autopan
(requires left and right limits to be set in Motion Parameters menu)
Autopan start:
99 - PRESET
Autopan stop:
96 - PRESET
9.2
Changing the Settings
To change a setting, proceed as follows:
1.
AUX ON
-
200
-
Enter
to enable the OSD using Bosch protocol (Bilinx or Biphase
connection); Pelco protocol (RS485-2 connection) uses 95 - PRESET.
2.
Move the cursor to the parameter to be changed.
3.
Press the confirmation (
Focus
) button. The field starts flashing, indicating that it is in
change mode. Operating the joystick (up and down) shows the alternative choices.
4.
After identifying the desired selection, press the confirmation (
Focus
) button; the
parameter stops flashing.
5.
To go back one menu, press (Iris) button; continue to press (Iris) button to exit the OSD.
9.3
Changing the Numeric Fields
To change a numeric field, proceed as follows:
1.
Use the joystick to scroll to the parameter you would like to edit.
2.
Press the confirmation (
Focus
) button. The cursor starts flashing for the character to be
changed, indicating it is in edit mode.
–
The minimum and maximum values allowed are displayed at the bottom of the
screen. If you try to insert a value outside the limits, the field is forced to the
minimum or maximum allowed value.
–
Operating the joystick (up and down) shows the alternative choices. If there is more
than one field on the same line, it is necessary to select the field by moving the
joystick (left and right).
3.
After making the change, press the confirmation (
Focus
) button.
–
The first digit in the numeric field to be changed flashes and the last line of the
display shows the accepted limits for the field.
–
Move within the field (left and right) and change the sign or the numeric value
(up and down).
4.
To go back one menu, press (Iris) button; continue to press (Iris) button to exit the OSD.
