46
VI.
VI.
Component Access/Replacement
Component Access/Replacement
Heater s &
Heater s &
NTC’s
NTC’s
–
–
Access (1)
Access (1)
The heater & NTC can be accessed or measured from
the right side of the dishwasher, but can only be removed
by dropping the entire base (by flipping the dishwasher
on its back) since they are wedged underneath the tank.
To remove outer door:
Remove six (6) T-20 Torx screws from inner door below
fascia panel (three (3) per side).
Carefully pull bottom of outer door out from dishwasher until
top door tabs clear, then pull door down until it releases
from dishwasher. Take care to not scratch outer door.
Remove two (2) plastic door guards. They can fall out when
the outer door is removed.
Remove inner door screws
Slide out outer door
Remove door guards
HINT:
Remove all water from the sump and hoses before accessing the heater --
when the dishwasher is flipped on its back, water can enter the water fill assembly
diaphragm and cause the dishwasher to not fill properly.
