Bosch Rexroth IndraDrive C HCS03.1, Planning Manual

Page: 59 / 86

Rexroth IndraDrive C HCS03.1 Electrical Data
6-21
DOK-INDRV*-HCS03.1****-PR02-EN-P
Note: If greater cable lengths are required, the additional component
HMF01.1 must be used.
The maximum allowed cable length with HMF01.1 is 200 m,
the maximum allowed switching frequency of the drive
controller in this case has to be limited to 4 kHz.
Note: If two motor cables connected in parallel are used between
drive controller and motor, the maximum allowed length of the
motor cable is reduced by half.
X6, Motor Temperature Monitoring and Motor Holding Brake
Fig. 6-31: Terminal X6
Type No. of poles Type of design
Spring tension 4 Pins on device
Fig. 6-32: Design X6
1
2 MotTemp-
Motor temperature monitoring
3 +24 V
4 0 V
Motor holding brake
Fig. 6-33: Pin assignment X6
HCS03.1E-W0070:
Cross section
single-wire
[mm²]
Cross section
multi-wire
[mm²]
Cross section
in AWG
1,5 1,5 16
Fig. 6-34: Connection cross section X6 (HCS03.1E-W0070)
HCS03.1E-W0100, -W0150 and -W0210:
Cross section
single-wire
[mm²]
Cross section
multi-wire
[mm²]
Cross section
in AWG
2,5 2,5 12
Fig. 6-35: Connection cross-section X6 (HCS03.1E-W0100 ... 0210)
Note: The brake is supplied via the optional 24 V control voltage.
Graphic Representation
Design
Connection
Connection Cross Section