Bolin Technology EX1020BHD-L5NXGA, User Manual

Page: 6 / 65

6
•
Mount laser dome camera at a height of six meters (19.7 ft) from the ground. To
avoid bodily injury from the laser radiation, please make sure that no one is
within the range of three meters (9ft) from the camera when the laser is working.
•
Never look at operating laser while the power is on.
•
Caution : Use of controls or adjustments to the performance or procedures other
than those specified herein may result in hazardous laser emissions.
Maintenance Precautions:
•
If there is dust on the front glass surface, remove the dust gently using an oil-free brush or a rubber dust blowing ball.
•
If there is grease or a dust stain on the front glass surface, clean the glass surface gently from the center outward using
anti-static gloves or an oil-free cloth. If the grease or the stain still cannot be removed, use anti-static gloves or an oil-
free cloth dipped with detergent and clean the glass surface gently until it is removed.
•
Do not use organic solvents, such as benzene or ethanol when cleaning the front glass surface.
Regulatory Compliance
FCC Part 15
This equipment has been tested and found to comply with the limits for digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
LVD/EMC Directive
This product complies with the European Low Voltage Directive 2006/95/EC and EMC Directive 2004/108/EC.
WEEE Directive
–2002/96/EC
The product this manual refers to is covered by the Waste Electrical & Electronic Equipment (WEEE) Directive
and must be disposed of in a responsible manner.