Bolin Technology EX1020BHD-L5NXGA, User Manual

Page: 46 / 65

46
ii. External PTZ Priority: The camera first tries to control the PTZ through the PTZ connected through
the serial port.
1. You can set this parameter only when Port Mode is set to PTZ Control .
2. When INTERNAL-PTZ is selected, this parameter is always set to Built-in PTZ Priority , and
it is unnecessary to connect the camera to an external PTZ through the serial port. Control
through the external PTZ is not effective even when the camera has been connected to an
external PTZ.
3. Set this parameter as required. Make sure PTZ control related interfaces are correctly
connected.
c. Address Code
i. Set the address code for the PTZ.
1. You can set this parameter only when Port Mode is set to PTZ Control and PTZ Protocol is
not set to INTERNAL-PTZ.
d. Click Save .
Transparent channel
Use the RS485 serial port to achieve transparent data
transmission with the third-party device.
1. Click Setup > System > Ports & Devices , and then click
the Serial Port tab.
2. Select Trans-Channel from the Port Mode drop-
down list.
3. Click Save .
OSD
To display information from the third-party device on the OSD, you need to select OSD as the port mode. The camera
receives information from the third-party device through the RS485 serial port, translates the received information, and
then displays it on the OSD.
NOTE:
To enable the camera to correctly translate information received from the third-party device, make sure that the
information sent by the third-party device through the serial port complies with the data format specified by our company.
For more details, contact your dealer.
1. Click Setup > System > Ports & Devices , and then click the
Serial Port tab.
2. Select OSD from the Port Mode drop-down list and
select Enable OSD Report . Then OSD data will be
reported to the management platform.
3. Click Save .