Bolin Technology EX1020BHD-L5NXGA, User Manual

Page: 47 / 65

47
Transparent Channel Configuration
Transparent channel is mainly used to achieve transparent data transmission between two devices.
NOTE:
•
This function is not supported by some models, please see the actual model
for details.
•
Make sure that you have set Port Mode to Trans-Channel for your camera.
•
The actual displayed Web interface may vary with the device model.
1. Click Setup > System > Ports & Devices , and then click the Trans-
Channel tab.
2. Select Enable for Trans-Channel .
3. Enter the destination IP address and port number (IP address and
port number that the transparent channel connects to).
4. Click Save .
Wiper Control
You can set the wiper parameters to control the housing and the PTZ wiper operation.
1. Click Setup > System > Ports & Devices , and then click the
External Device tab.
2. Set the wiper control mode and the parameters to enable wiper.
NOTE:
•
Serial Port: The wiper is controlled through PELCO-D instructions. Please set the PTZ protocol to PELCO-D.
•
Normally Open/Closed: The wiper is controlled through alarm input/output settings, including normally open and
normally closed.
•
Enable Wiper: This function is available only in alarm input/output mode.
Viewing Device Status
You can view the current status of your camera.
1. Click Setup > Common > Navigation .
2. Click Refresh for the latest status information.
3. View the device information.