BOGBALLE L15 base, Operator'S Manual, Page: 15 / 96

15
Figure 3 Figure 4
Top of the crop
Figure 2
3 - How to do headland spreading
3.1 Check that the spreader is in headland spreading mode
(see chapter ’Normal and headland spreading’ page 39)
The same vane is used for both normal and headland spreading
3.2 Set the PTO speed according to the spread chart
4 - How to do normal spreading
4.1 Check that the spreader is in normal spreading mode
(see chapter ’Normal and headland spreading’ page 39)
4.2 Set the PTO speed according to the spread chart
Figure 1
2 - How to set the spreader
2.1 Standard working height: 75 cm from the upper link to the top of the crop
(see figure 1)
Special for L15. Standard working height: 55 cm from upper link to top of the crop
For late application see chapter ’Spreader settings/Working height - late application’ page 52
2.2 Find the relevant spread chart on www.bogballe.com or via the BOGBALLE Spread Chart app
(see chapter ’Spread Charts’ page 21)
2.3 Make sure that the scale stop is fixed at scale 9
(see figure 2)
2.4 Carry out a calibration for quantity setting
2.5 Check type of vanes according to spread chart
2.6 Set the position of the vanes according to spread chart
2.7 Set the tilt angle of the spreader according to spread chart
(see figure 3)
Special for L15. Always horizontally levelled
(see figure 4)
1 - Mounting
1.1 Mount the spreader in levelled position
1.2
Check that the PTO has a correct length in order not to damage the transmission.
(For further information see page 10 and 50)
1.3 Remember to calibrate your speed input (see the CALIBRATOR’s manual)
Quick Guide - M45, M35, L20, L15 with CALIBRATOR