28-6-2011 22 033000=13069F
Every lamp or appliance controlled by the system needs to be equipped with an X10 receiver
module. These modules are easy to install (Plug & Play) and are also available separately, which
means you can expand the system as you wish and when you wish.
A few of the Plug & Play modules:
LM12
Lamp/Dimmer Module Plug-in module to switch and dim lighting.
AM12
Device/Switch Module. Plug-in module to switch lighting and electrical equipment.
LM15
Bayonet Lamp Module or Screw-In Lamp Module to switch lighting.
More information on these modules can be found on
www.bmbelectronics.eu
or you can
contact your local dealer.
7.2 Addressing your modules
An address can be set for every X10 module. This address consists of a HOUSE CODE (A-P) and a
UNIT CODE (1-16). The HOUSE CODE of all your components needs to be set to the same letter
code (Note: Check also 10.6 for more info before setting the addresses). With the UNIT CODE
you can give every module its own number, so that they can be individually controlled (via the
number pad on your console, with the SH600 Comfort Remote Control, or any other X10
compatible controller).
7.3 Installing the LM12 Lamp/Dimmer Module
1. HOUSE CODE SWITCH: To set up the system address.
2. UNIT CODE SWITCH: To set up the module number.
3. WALL SOCKET: To connect the lamps you want to switch using
the module.
4. FUSE (at the back): The fuse protects the lamp/dimmer module
against a power overload. If the fuse blows, it can only be
replaced by another fuse of the same type.
INSTALLATION LM12:
Plug the lamp/dimmer module into a free wall socket (230V/50Hz)
and plug your lamp (40-300W) into the module. To avoid damage,
do not plug in any other loads - such as household equipment or
TL/PL lights - into the module. Use an AM12 Appliance/Switch
Module or a LM15 Lamp Module for these types of loads.
7.4 Alarm functions of the Lamp/Dimmer Modules
When Arming the system via the console, the lamps on A1 and A2 will be switched on during
the Exit Delay. As soon as the system is activated, the lamp will be switched off.
When Arming the system via remote control, the lamps will be switched on and off quickly to
indicate the system is activated (comparable to the alarm system of a car).
In the case of an alarm the lights connected to lamp/dimmer modules with addresses A1 and
A2 will flash. After 4 minutes the lights will remain on.
7.5 Comfort functions of the KR18 Key Chain Remote Control
Switch and dim lights remotely. Switch the garden lamps when you enter your property, never
enter your home in the dark.
Press the
A LIGHTS ON
or
B LIGHTS ON
button. The lamps on respective address A1 or A2 will be
switched On.
Press the
A LIGHTS OFF
or
B LIGHTS OFF
button. The lamps on respective address A1 or A2 will be
switched Off.
7.6 Comfort functions of the SH600 Comfort Remote Control
