28-6-2011 18 033000=13069F
4.4.2 Use of the TS10 Thermostats
The RF DigiMax210 Wireless thermostat does not need any extra wiring and works within 30
meters range. It is equipped of a secured RF code which the SC28 Base Console will learn
during the installation process. This code will assure that the Security Base Console or Home
Controller will only answer to messages sent by your DigiMax210. You can connect up to 4
DigiMax210 to the Maxi Controller. Depending on the information sent by the thermostats, the
SC28 Base Console will send X10 Home Automation Messages on the power line to turn On or
Off X10 modules connected to your heaters or boiler. Besides heating the Thermostat can be
used for cooling as well.
The respective Home Automation addresses are HC+1 UC13-16 for thermostats 1-4, so e.g.
when Base Console has been set to default Base Address A1, T1 sends messages to B13.
5. Setting up the Security Console (SC28)
5.1 Setting the clock
1. To access the menu, press either the menu UP or DOWN button. The display now shows
ENTER PIN
.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word
INSTALL
will show up on the
display.
4. Use the menu buttons UP/DOWN to go to menu item
2. SET CLOCK
. Press OK to select this
menu item. You can also go to this menu item directly by pressing a 2 on the number pad.
5. Use the menu buttons UP/DOWN to select the correct day of the week.
6. Use the number pad to enter the new time (24 hour notation), followed by OK. The display
now reads
INSTALL
.
7. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2 for No. If you
choose Yes, you will quit the menu. If you choose No, you go back to the first menu item. .
If you press CLEAR while entering the time, the time entered will be deleted.
5.2 Storing phone numbers
The SC28 console has a built-in telephone dialler. In case of an alarm up to 6 telephone
numbers can be dialled. All persons called will be able to listen to the message you have
recorded (5.3). The message needs to be confirmed by the person answering the phone by
pressing a 0 on their phone (DTMF response). The dialler then knows the next number does not
need to be called.
NOTE: You are not allowed to use emergency numbers, i.e. the police and security
companies, unless you have been granted permission.
First make a list with the phone numbers you want to enter, in the order they need to be
dialled. If you have connected the console via an PABX phone system, you may need to add
a 0, or possible other digit in front of the telephone number to get an external land line.
1. To access the menu, press either the menu UP or DOWN button. The display now shows
ENTER PIN.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word
INSTALL
will displayed.
4. Use the menu buttons UP/DOWN to go to menu item
3. PHONE NUMS.
Press OK to select
this menu item. You can also go to this menu item directly by pressing a 3 on the number pad.
5. Use the menu buttons UP/DOWN to go to the memory space where you want to enter a
telephone number (
PHONE 1, PHONE 2 … PHONE 6
).
6. Press OK when you have arrived at the memory space. After pressing OK at PHONE
1, the display will read
SET PH 1.
