28-6-2011 19 033000=13069F
7. Enter the telephone number. Press the OFF button for a dial pause (use a dial pause
between the extra 0 and the telephone number when the console is connected to a PABX
phone system. A small letter
P
can now be noticed on the display).
8. Press OK. You will now automatically go to the next memory space.
9. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2 for No. If you
choose Yes, you will quit the menu. If you choose No, you go back to the first menu item. .
If you press CLEAR while entering a telephone number, the number entered will be deleted.
IMPORTANT:
It’s mandatory to have all 6 positions programmed. It’s allowed to program the
same number on different locations, but be aware if you program less than 6 different
telephone numbers, the console will try to contact you at these numbers several times in case
of an alarm.
As soon as the call is confirmed by a DTMF “0” press from a phone, the console will stop
dialling.
5.3 Recording your own message
You can record an own message that will be used by the telephone dialler. The message can
be up to 12 seconds long. Make sure the message is not too short, because this will cause a
long silence period when the message is played and repeated.
Example: “This is the security system of ...... Press 0 after the message to hear what is going on.
Please undertake action as agreed.”
1. To access the menu, press either the menu UP or DOWN button. The display now shows
ENTER PIN.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word
INSTALL
will show up on the
display.
4. Use the menu buttons UP/DOWN to go to menu item
4. MESSAGE
. Press OK to select this
menu item. You can also go to this menu item directly by pressing a 4 on the number pad.
5. Press 1 for
RECORD
.
6. The display now shows
PLEASE WAIT.
7. When the display reads
SPEAK NOW
you can record your message (max. 12 seconds). The
distance to the microphone should be more or less around 30 cm.
8. After recording, wait until the
RECORD/REPLAY
option comes up again.
9. Press 2 (REPLAY) to listen to the recorded message.
10. Press CLEAR to quit the menu. To confirm this choice, press 1 for Yes or 2 for No. If you
choose Yes, you will quit the menu. If you choose No, you go back to the first menu item.
6. Using the Pr Security System
6.1 Setting the alarm
The system has two different alarm functions:
1)
ARM AWAY
: Full alarm. All registered Sensors will be activated.
2)
ARM HOME
: Partial alarm. All Door/Window sensors will be activated, but the motion
detectors are not armed. This means you can walk around the house, while the ‘shell’ of
is protected.
a) A
single
press arms all Door/Window Sensors
b) A
double
press of
ARM HOME
results in every sensor to be active in zones 1-16 but motion
detectors are still not active in zones 17-30. All Door/Window Sensors are however active
in zones 17-30.
