28-6-2011 15 033000=13069F
A memory space for a sensor is called a zone. If you have more than 1 sensor installed, it will
show e.g.
ZONE 2 SET, ZONE 3 SET, … ZONE 30 SET
.
You can choose in which zone you want to install the sensor. If you want to install the sensor in
zone 3, press 3 on the number pad before executing step 5.
It’s advisable to write down which zone contains which sensor. There’s space reserved at the
back of this user manual.
6. Repeat step 5 for every door/window sensor you wish to register.
7. Press CLEAR to go back to the first menu item. Press CLEAR again to quit the menu. To
confirm this choice, press 1 for Yes or 2 for No. If
you choose Yes, you will quit the menu. If you
choose No, you go back to the first menu item.
4.1.4 Adding a wired sensor to the D/W sensor
The DS18 Door/Window Sensor has a contact for
an extra wired sensor. These sensors need to be of
type NC (normally closed dry contacts) and there
should not be any power on this contact
(potential-free).
1. Open the transmitter part of the DS18.
2. Remove the wire bridge from the connection
for the wired sensor (6).
3. Connect your additional sensor.
The wired contact can have its dedicated zone
registration on the Security Base Console. You can
register the contact using the procedure as
described above.
To register the sensor, trigger the alarm of your
wired sensor while in registry mode.
4.2 Motion Detector MS18
1.
Control Indicator
- Lights up when a signal is transmitted.
2.
PIR
