28-6-2011 17 033000=13069F
4.3 Additional (Wireless) Emergency Sensors (*OPTIONAL)
The Additional (Wireless) Sensor make sure you are warned in case of an emergency. When
you’re at home, the built-in siren will be triggered. Combined with your security system the
internal siren, the telephone dialler and the lights will be activated. This gives you an optimal
warning and makes sure your exits are well lit. If you are away from home, you will receive a
warning via your mobile phone.
The telephone message indicates that an Emergency Sensor has been triggered and that it is
not the burglar alarm. This is done by adding an extra message to your own spoken telephone
message. This standard multi-lingual message is pre-programmed into your system.
4.3.1 Registering the Additional (Wireless) Sensor with the Console
1. To access the menu, press the menu UP or menu DOWN button. The display now shows
ENTER PIN.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word
INSTALL
will show up on the
display.
4. Press OK.
5. Insert the batteries into the detector (see the user manual of the additional sensor for more
information). The console will beep to confirm. The display will read
RMOT 3 SET
or
ZONE …’. SET
.
The Additional (Wireless) Sensor works most likely the same as a remote control (panic
function). It will make sure the security system will call you, even if the system is not activated.
Other option is the function of a D/W sensor. If you have one or more remote controls or
additional sensors installed, the display will read e.g.
RMOT 4 SET, RMOT 5 SET, … RMOT 16 SET
or
ZONE 2 SET, ZONE 3 SET, … ZONE 30 SET
. You can register up to 16 remote controls and/or
additional panic detectors based on remote panic function, or up to 30 sensors in case of
wireless alarm sensor function.
6. Repeat step 5 for every additional sensor you wish to register.
7. Press CLEAR to go back to the first menu item. Press CLEAR again to quit the menu.
If required you can remove Additional (Wireless) Sensors from the memory. This method is
described in 8.2.
All information on mounting the respective detector can be found in the user manual of the
respective detector.
4.4 Thermostat TS10 DigiMax210 (*OPTIONAL)
The DigiMax210 is available separately. Please visit
www.bmbelectronics.eu
for more
information.
4.4.1 Registering a Thermostat
1. To access the menu, press the menu UP or menu DOWN button. The display now shows
ENTER PIN.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The
display is cleared and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word
INSTALL
will show up on the
display.
4. Press OK. The display will read
INSTALL ZONE
.
5. Set the Thermostat to registering mode (see respective manual). The console will beep to
confirm. The display will read
THST…’. SET
.
If you have more than 1 thermostat installed, it will
show e.g.
THST 2 SET, THST 3 SET, … THST 4 SET
.
6. Repeat step 4 for every Thermostat you wish to register (up to 4).
7. Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2 for No. If you
choose Yes, you will quit the menu. If you choose No, you go back to the first menu item.
