17
Install the safety flow switch on the metal fitting using the bushing so that the arrow is pointing in the direction of
the water flow.
Make sure to fit an O-ring gasket between the bushing and the metal connector, which can be found inside the
protective cover of the safety flow switch rod.
- Connect the water circuit to the opposite end of the tee connection.
- Bring the safety switch cable over to the electrical box. Connect the safety flow switch to the terminals 1-14.
Always refer to the electrical diagrams enclosed with the unit.
- Unscrew the bushing should it be necessary to remove the flow switch. When refitting the flow switch, refit the
ring seal (see figure).
On Heat Pump units the hydraulic connection to desuperheater must be
On Heat Pump units the hydraulic connection to desuperheater must be
On Heat Pump units the hydraulic connection to desuperheater must be
On Heat Pump units the hydraulic connection to desuperheater must be
On Heat Pump units the hydraulic connection to desuperheater must be
by-passed when working as heat pump.
by-passed when working as heat pump.
by-passed when working as heat pump.
by-passed when working as heat pump.
by-passed when working as heat pump.
4.5 WATER CONNECTION TO THE DESUPERHEATER
4.5 WATER CONNECTION TO THE DESUPERHEATER
4.5 WATER CONNECTION TO THE DESUPERHEATER
4.5 WATER CONNECTION TO THE DESUPERHEATER
4.5 WATER CONNECTION TO THE DESUPERHEATER (optional)
(optional)
(optional)
(optional)
(optional)
On all units provided with a desuperheater, the relative hydraulic connections consist of male threaded steel pipes
and are identified with dataplates as indicated in the figure below.
Recovery water inlet:
Recovery water outlet:
FLOW DIRECTION
ARROW
FLOW SWITCH
ELECTRIC CABLE
LOCK NUT
O-RING
T CONNECTOR
IN
RECOVERY WATER
OUT
RECOVERY WATER
Summary of Contents for KAPPA V 2001
Page 69: ......
