Black Box MT1000A-13-R3, Quick Start Manual

Page: 3 / 78

Installing MT1000A 1
Quick Start Guide
If you are familiar with the MT1000A, use this guide to prepare it for operation.
Perform the following steps.
1. Installing MT1000A
Connecting the Tributary T1 Interfaces
To connect the balanced T1 interface (RJ-45 connector)
• Connect the RJ-45 connector of the cable to the T1 port.
Connecting the Uplink
To connect a fiber optic uplink
1. Clean the optical connectors using an approved solvent, and dry thoroughly
using optical tissue.
2. Connect to the two optical connectors designated TX (transmit output) and
RX (receive input) of the appropriate interface.
3. Pay attention to correct connection of the transmit and receive cables to the
corresponding connectors. Avoid sharp bends and twisting of the fiber-optic
cables.
For WDM option, only one fiber optic cable per link should be connected.
Note