Digital Power Meter Display, 5000-NG
15
CCDF Limit —
For Wideband Power Sensors:
Enter the threshold to be used for CCDF measurement. See CCDF
Note:
Statistical Power Sensors (7022) have numerous unique
configuration settings, for a description of these settings see Statistical
Power Sensor Measurements.
Bandwidth —
For Statistical Sensors:
Set bandwidth (filter value), this filter can be set to either 4.5 kHz, 500 kHz, 5
MHz, or None (no filter, full bandwidth). See Bandwidth (Video Filter).
Correction Frequency —
For Statistical Sensors:
Enter the frequency under test, or allow sensor to automatically detect
frequency under test (default).
Duty Cycle —
For Statistical Sensors:
Enter the Duty Cycle of the system under test, or allow sensor to automatically
detect the Duty Cycle of the system under test (default).
Sample Interval —
For Statistical Sensors, Time Domain Measurement:
Select the desired time interval between samples (this will affect the length of
time required to complete Time Domain Measurement).
Trigger settings —
For Statistical Sensors, Time Domain Measurement:
Select trigger source, trigger mode, trigger edge, trigger level, trigger hold off, or
trigger delay. See Time Domain Mode.
Run Mode —
For Statistical Sensors, Statistical Measurement:
Select whether a single measurement is acquired, or measurements will
automatically be repeated.
Confidence, Sample Time, and Sample Count —
For Statistical Sensors,
Statistical Measurement:
Select one of these settings to adjust, Confidence, Sample Time, or Sample
Count. Setting one of these affects the other two settings, only one needs to be
adjusted for each measurement, see Confidence Percentage.
Dynamic Range —
For Statistical Sensors, Statistical Measurement:
Select the decibel measurement range for each measurement, this setting will
determine the values on the x-axis of the graphed results.
Graph Displays
Any measurement can be displayed in graphical or tabular format. Several
different graph types may be displayed.
Tap the Display Controls Menu
to display the graph options.
Graph List —
Default options are Reading Table, New Bar Graph, New Time
Graph, and New Data Set Graph (CCDF and Time Domain modes only). Any saved
graph for the current sensor/mode will also be displayed on the list. See How to
Display a Graph.
Reading Table —
The reading table displays all of the connected unit's
measurements in a tabular
format. The reading table will be displayed until a different option is selected.
