Bilanciai Cigiemme MERCURY PLUS, Instruction Manual

Page: 162 / 260

MERCURY PLUS
1-162
the machine will automatically load the data item read in the global field
(see below) during the process, when the barcode is read, instead of in
the plu.
The scanner that reads the data only functions during the processing
phase.
The machine configuration contains an item that enables the scanner to
read the data, plus the relative serial port and barcode ID used for
reading. There is also a field that enables macro key F11 during the
process. This allows the ID of the barcode in progress to be changed
during the process just as key F12 changes the plu in progress if
enabled.
ERROR SITUATIONS:
The following checks are available in the CRATE WEIGHER mode with
scanner reading:
✔
there are no checks on access to the process.
✔
An error is activated and stops the process if the terminal reads a
code whose size is less than the position (and length) of a field to be
read inside it.
✔
If present in the selected barcode, the traceability fields are ignored.
✔
Checks are made to ascertain the existence or presence in the setup
of the barcode ID for reading during access to the process, with
process block.
The following checks are available in the SINGLE PRODUCT mode with
scanner reading:
✔
Before accessing the process, the terminal checks to make sure that
the selected barcode exists.
✔
Before accessing the process, the terminal checks to make sure that
the fields set in the barcode are valid.
✔
Before accessing the process, the terminal checks for the presence of
different traceability fields from the lot or whether traceability has
been enabled in the lot field.
✔
An error is activated and stops the process if the terminal reads a
code whose size is less than the position (and length) of a field to be
read inside it.
✔
An error is activated and stops the process if a traceability lot is read
but is not present in the archive.