Bernina Artista 730, Instruction Manual

Page: 262 / 285

258
Embroidery Support – Messages
Message
•
Cannot dial, please check the phone line and then dial
number.
•
The authentication for the provider failed. Please check
the username and the password.
•
The communication with the provider was interrupted.
Please try later or use another provider.
•
An unknown error occurred with the Modem. Please try
again.
•
You cannot save or delete files on the myartista Portal.
•
A problem occurred in communicating with the myartista
Portal. Please try again.
•
Your sewing/embroidery computer has now reached the
time limit, where in order to guarantee continuous satis-
factory work, the following small tasks should be carried
out. Remove thread and lint and remnants from beneath
the stitch plate, as well as from the feed dog area. These
instructions can be found on page 185 of the manual.
•
Your sewing/embroidery computer has now reached the
time limit, where your BERNINA dealer will be pleased to
give it a service check.
•
You have opted for the possibility not to take your
sewing/embroidery computer to your BERNINA dealer. This
message will therefore only come on again after the next
period of sewing/embroidering has been accomplished.
•
Main Motor failed. Please check hook system.
Note
Check the settings in the Setup Program
and try again.
Check the settings in the Setup Program
and try again.
Connecting problems. Enter another
provider if possible or try again.
Remove modem, then reconnect.
The myartista portal provides tips and
news.
Try to connect to myartista portal again.
Remove modem and reconnect in
necessary.
This message appears at approx.
180'000 stitches. Press «OK» to close
message after cleaning and oiling. Press
«ESC» to temporarily «delete» the mes-
sage. It will, however, reappear after
restarting the sewing/embroidery com-
puter. After «deleting» it three times by
pressing «ESC», the message will not
appear again before another approx.
180'000 stitches will have been stit-
ched.
Take the sewing/embroidery computer
to the BERNINA dealer for servicing. This
message appears at approx. 2'000'000
stitches. After servicing, the stitch coun-
ter is reset to «0» by the Bernina servi-
cing staff. Press «ESC» to temporarily
«delete» the message. It will, however,
reappear after restarting the
sewing/embroidery computer. After
«deleting» it three times by pressing
«ESC», the message will not appear
again before another approx. 2'000'000
stitches will have been stitched (i.e. at
4'000'000 stitches).
Flawless functioning of the
sewing/embroidery computer can not
be guaranteed if the servicing is not car-
ried out at the recommended regular
intervals.
Open bobbin cover. Remove lint and
thread remnants and clean hook
system.
032131.70.04_0509_a730_EN