BendPak RS7580V-601, Installation And Operation Manual, Page: 36 / 44

RS7580V-601 Rotary-Screw Air Compressor
36
P/N 5900090 — Rev. A — Sept. 2019
Troubleshooting
This section describes how to troubleshoot your Compressor.
⚠
WARNING: Disconnect the Compressor from power before performing any
maintenance and take whatever steps are necessary to make sure the unit
cannot be re-energized while maintenance is being performed on it. The
Compressor creates pneumatic energy and uses electrical energy; if your
organization has Lockout/Tagout policies, make sure to implement them before
troubleshooting the unit.
If your unit is not functioning correctly, you must take it out of service until it is fixed.
Important
: All repair work must be done by qualified personnel.
Issue Action to Take
Compressor does not run. Check the power supply, from inside the Electrical Box to the
facility’s power system. Make sure breakers are working correctly.
Make sure wiring is connected correctly; wiring can become loose
during transport.
Compressor starts and
stops frequently.
Check for leakage in the facility’s air pressure system.
Check for tool that continues to take air.
Check settings for start and/or stop thresholds.
Compressor does not
reach expected pressure.
Check for leakage in the facility’s air pressure system.
Check for blockage in Air Filter.
Oil level too low. Make sure there is enough oil to begin with. If it goes low again,
check for an oil leak. Make sure an appropriate oil type is being
used.
Excessive vibration or
noise.
Make sure Vibration Pads are in place. Make sure Anchor Bolts are
not too tight. Check connections to the facility’s air pressure system.
Screen display is on, but
motor is not running.
Check the breakers in the Electrical Box.
If you continue to have problems with your unit, contact your dealer, visit bendpak.com/support ,
email
techsupport@bendpak.com
, or call
(800) 253-2363
, extension 196.