RS7580V-601 Rotary-Screw Air Compressor
18
P/N 5900090 — Rev. A — Sept. 2019
Anchor the Feet
If desired, you can anchor each of the four feet on the Compressor. This provides extra stability for the
unit. Anchoring the feet is optional; anchor bolts are not provided.
Important
: Whether you decide to anchor your Compressor or not, remember to use the supplied
Anti-Vibration Pads between the Compressor feet and the ground.
Recommended Anchor Bolt specifications: wedge anchors; 3/8 in wide by 3.5 in deep; torque to 55
pound feet.
To anchor the Compressor feet
:
1.
Make sure the Compressor is in the desired location.
Once anchor bolts are torqued into position, they are not easily removed. BendPak strongly
recommends making sure the Compressor is in the desired location
before
anchoring it into
place.
2.
Put the Anti-Vibration Pads under the feet of the Compressor.
3.
Using the holes in the feet as guides, drill the holes for the Anchor Bolts through the Anti-Vibration
Pads and into the concrete.
Go in straight; do not let the drill wobble.
Use a carbide bit (conforming to ANSI B212.15).
The diameter of the drill bit
must
be the same as the diameter of the Anchor Bolt. So if you are
using a 3/8 inch diameter Anchor Bolt, for example, use a 3/8 inch diameter drill bit.
4.
Use a vacuum to thoroughly clean each hole.
If a vacuum is not available, use a wire brush, hand pump, or compressed air.
Do
not
ream the hole. Do
not
make the hole any wider than the drill bit made it.
5.
Put the washer and nut into place, make sure the top of the nut is flush with the top of the Anchor
Bolt, then insert the Anchor Bolt into the hole.
6.
Hammer or mallet the Anchor Bolt down into the hole.
Stop hammering when the washer is snug against the top of the foot.
7.
Wrench each Nut
clockwise
to the recommended installation torque, 55 pound feet, using a
torque wrench.
Important
: Do
not
use an impact wrench to torque the Anchor Bolts.
Wrenching the nut forces the wedge up, pushing out the expansion sleeve and pressing it tightly
against the concrete.
Summary of Contents for RS7580V-601
