RS7580V-601 Rotary-Screw Air Compressor
26
P/N 5900090 — Rev. A — Sept. 2019
Startup
When the Compressor goes from having no power to having power, the Display Screen goes through
a Startup process.
On power up, the Display Screen shows:
WELCOME TO USING YOUR SCREW COMPRESSOR
Also, the Power indicator comes on.
After a few seconds, normal operating information appears (similar to the following):
AIR T: 90°F
P:160 PSI 239V
NORMAL STOP
Line 3 will briefly show
STARTING
(with a countdown), then
RUNNING
, and finally the normal operating
status.
When you see the above information on the Display Screen, the Compressor has started up correctly
and is ready for normal operation.
Normal Operation
During normal operation, the Compressor is receiving power and is either building pressure in the Tank
or waiting for the Tank pressure to fall below the configured threshold.
⚠
DANGER
During normal operation, the Compressor can start operating with no warning. If
the Compressor turns on while you are touching it or standing in the wrong place,
you could be injured or, in rare cases, killed. Until you are certain that power has
been removed from the Compressor and it cannot be reenergized, stay outside the
Safety Exclusion Zone. Only trained Operators should ever be inside the Safety
Exclusion Zone and only when necessary.
To put the Compressor into normal operation
:
1.
Check the Display Screen to make sure the Compressor is in a NORMAL STOP state.
If the Compressor was stopped using the Emergency Stop button, it may still be in an
EMERGENCY STOP state. If this is the case, turn the Emergency Stop button to the right to reset
it; the Compressor will change to a NORMAL STOP state.
If the Display Screen is off, check to make sure the Compressor is getting power.
2.
Make sure the Ball Valve on the Discharge Port is set to open.
3.
Press the green Start button (
I
).
The Run indicator comes on, the Compressor motor starts up, and the Compressor starts
pressurizing air and storing it in the Tank.
If the Tank is full or close to it, the status of the Compressor (as displayed on the Display Screen)
may quickly go to AUTO UNLOAD. If the Tank is empty or not nearly full, the status will go to AUTO
LOAD and stay there as the Tank fills.
4.
The Compressor is now operating normally.
During normal operation, status will change from AUTO LOAD to AUTO UNLOAD as the
Compressor switches between these two states.
Summary of Contents for RS7580V-601
