Bend-Tech Dragon A250 Series, Assembly Manual

Page: 17 / 44

17
Bend-Tech Dragon A250
Assembly Manual
Assembling the Dragon
03
3.3.2 Miscellaneous Box
Locate the Miscellaneous Box, and remove the swivel levelers and hardware bags. These will
be used during the assembly process.
The Dragon A250 Rail Support Legs are mounted to the floor of the shipping crate
using the Floor Brackets. When assembling the machine, the Floor Brackets should be
left in place. The Installer will use the Swivel Levelers to true the machine then bolt it
to the floor using the Floor Brackets.
Installing Swivel Levelers
Tools Needed
• ½ in. wrench
•
11/16 in. wrench
The Installer will be required to
install two Swivel Levelers in
each Support Leg. Each base
of the Support Leg will have a
bracket with a threaded hole.
Prepare the Swivel Leveler for
installation by positioning the jam
nut approximately one inch above
the adjustment hex at the bottom of the Swivel Leveler.
Thread the Swivel Leveler into the threaded hole in the base of the support leg
until it bottoms out on the adjustment nut. This method will place all of the Swivel
Levelers at approximately the same distance, providing a baseline for levelling the
machine.
Install Swivel Levelers on each support leg as the installation progresses. An 11/16
in. wrench may be needed to thread the Swivel Levelers into the bottom of the
Support Legs.
Swivel
Leveler
Leg Bracket
Installing the Swivel Levelers may require help.