Bend-Tech Dragon A250 Series, Assembly Manual

Page: 32 / 44

32 Bend-Tech Dragon A250 Assembly Manual
Mounting to the Floor
05
7/16 in. Concrete Drill 3/8 in. Concrete
Sleeve Anchor
5.3 Preparing the Floor Brackets
With the machine level and true, loosen the Floor Brackets on the Rail Support Legs so they
are snug, but can be lowered to the surface of the floor. Using a marker or pencil, mark the
floor where the concrete sleeve anchor will be placed.
Remove the Floor Brackets from the machine. Removing the Floor Brackets makes it easier to
drill the holes for the concrete sleeve anchors.
Drill the holes to the depth specified by the concrete sleeve anchor manufacturer. Once holes
are drilled, clean the holes out with a vacuum or compressed air. Re-install the Floor Brackets
on the machine. Do not tighten the Floor Brackets onto the Support Legs at this time. Ensure
the Floor Brackets are snug to the Support Leg, but that they are still able to be adjusted by
the Installer.
5.4 Install Concrete Sleeve Anchors
With the Floor Bracket snug on the Support Legs but still adjustable, line up the hole in the
Floor Bracket with the hole drilled in the concrete. Insert a concrete anchor into the hole. Tap
the concrete anchor into place lightly with a hammer, ensuring the Floor Bracket is flush with
the floor and the concrete sleeve anchor is snug to the Floor Bracket. Tighten the concrete
sleeve anchor nut with fingers. Using a ½ in. socket and torque wrench, torque to manufacturer
specs (typically 8 lb ft. for ⅜ in. concrete sleeve anchor). Tighten the Floor Bracket to the Rail
Beam Support Leg.