Bend-Tech Dragon A250 Series, Assembly Manual

Page: 19 / 44

19
Bend-Tech Dragon A250
Assembly Manual
Assembling the Dragon
03
Using a forklift, approach the head of the
machine from the front. Position the forks
under the head in the indicated position. It is
recommended to use fork extensions and lay
blocks of wood across the forks to support
the beam of the machine.
Carefully lift the head of the machine off the
crate floor and slowly move it into position.
Before placing the head, leave adequate
space for the remaining sections of the
machine to be put into place. The Dragon
A250 requires a minimum of 28-feet of space.
3.5.2 Install the Head Supports
The left side (cable track side) head supports are shrinked
wrapped to the supports on the right side of the machine. After
positioning the head, install the left side supports as shown;
use a 9/16 in. wrench to tighten the bolts.
Position Forks Here
Head of Machine
Before placing the machine, ensure
the Swivel Levelers are installed in
each of the Support Legs as outlined
in Section 3.3.2.
Important
Due to its size and weight, Bend-Tech
does not recommend placing the head of
the machine manually.
Support the beam when
moving the Head with a forklift.