Bend-Tech Dragon A250 Series, Assembly Manual

Page: 24 / 44

24 Bend-Tech Dragon A250 Assembly Manual
Assembling the Dragon
03
3.7.1 Place and Install the Tail
The tail section of the machine comes pre-assembled. Remember to install swivel levelers on
the bottom of the two support legs before placing and installing the tail.
Use the stainless steel locator pins to align the tail of the machine with the end of the beam,
which should be labeled 5. Ensure that there are no gaps between the beam and rail sections.
3.7.2 Secure the Tail Support Leg to the Second Beam
Secure the tail support leg to the beam the same way the previous support legs were fastened
to the beam, using the magnet tool and a 3/16 in. Allen wrench.
3.8 Securing the Rail Sections
The rail splices should be secured to the beams using the ⅛ in. Allen fasteners from Hardware
Bag No. 3. They only need to be secured at the rail joints. There are four screws needed for
each joint. Once the rail sections are secure and tight, tighten all the fasteners securing the
support legs.
Remember
After securing the rail sections, remember to tighten all the fasteners securing
the support legs to the beams, including those located on the underside of the
beams that secure the beams to the support leg brackets.
Secure the rail splices
to the beams