Belden Grass Valley Kaleido-Modular-X, Hardware Description & Installation Manual

Page: 18 / 96

18
Installation
Mechanical Installation
Mechanical Installation
Unpacking
Make sure the following items have been shipped with your Kaleido-Modular-X order. If any
of these are missing, contact your distributor or Grass Valley (see
Contact Us , on page 96).
• 1–4 KMX-3901-IN input cards with matching rear modules, as per order (see SDI Input
module parts , on page 12)
• 1–4 KMX-3901-IN-IP input/output cards with matching rear modules, as per order (see
IP module parts , on page 13)
• 1–4 KMX-3901-IN-M3 rear modules, M3 cables, and NVISION router-side rears, as per
order (see M3 module parts , on page 13)
• 1 or 2 KMX-3901-OUT output cards, with rear modules, as per order (see Output
module parts , on page 13)
• 1–16 12-inch FlexBridge cables (DIN-DIN coax cables), as per order
• 2 WECO analog audio mating connectors for each output card
• 2 serial port adapters (1 with straight cabling and 1 with crossover cabling — see RS-
422 connection diagram , on page 24) for every output card ordered with a double rear
connector panel
Number of FlexBridge cables for typical configurations (SDI inputs)
Model FlexBridge Model FlexBridge Model FlexBridge
8 × 1 1 24 × 1 2 48 × 2 6
8 × 2 2 24 × 2 4 48 × 4 12
16 × 1 1 32 × 2 4 64 × 2 8
16 × 2 2 32 × 4 8 64 × 4 16
16 ×4 4
Number of FlexBridge cables for IP-only configurations
Number of IP input/output cards 1 2 3 4
FlexBridge cables 2 4 6 8
Part number Adapter cabling RS-422 pinout at the DE-9P connector
1737-3000-102 Straight Controller (SMPTE master) mode
1792-3700-100 Crossover Tributary (SMPTE slave) mode
Note:
The single rear connector panel KMX-3901-OUT-D-3+SRP does not
have a serial port. To support a serial device, your Kaleido-Modular-X system
must have at least one output card with a double rear connector panel (KMX-
3901-OUT-D-3DRP).