Belden Grass Valley Kaleido-Modular-X, Hardware Description & Installation Manual

Page: 48 / 96

48
Installation
Replacing a GPI-1501 Card
3 Push the lever firmly down to release the controller so that it can slide freely.
4 Pull gently on the display panel and slide the controller out of the frame.
5 With the lever extended, slide the new controller gently into the controller slot as far as
you can until it stops.
Do not apply any force, as it may damage the controller/display interface.
6 Firmly push the lever up to seat the card in its connectors.
7 Be sure to close the front door before operating your Kaleido-Modular-X system, to
ensure proper ventilation (see Closing the front door , on page 41).
Replacing a GPI-1501 Card
In a Densité 3+ FR1 frame, the GPI-1501 card is located in a special slot, on the upper right-
hand side of the frame, above the (optional) right-hand power supply.
To replace a GPI-1501 card
1 Open the front door of the frame (see Opening the front door , on page 40).
2 Tilt the swivel handle, on the front of the card, to lever the connectors apart, and then
use the handle to pull the card straight out of the slot.
3 Slide the new GPI-1501 card into the slot — with the swivel handle to the right, if in a
1RU frame —, and push gently on the handle to seat the connectors.
4 Close the front door of the frame (see Closing the front door , on page 41).