Belarus 80.1/80.2/82.1/82.2/82
Р — Operation and Service Manual
Section 7. Maintenance Procedures
79
Table 8, continued
It
e
m
No
.
in
di
a
gra
m
Scope of operations performed
Maintenance intervals,
hr
Technical requirements
10
125
500 1000
16
FDA planetary-and-spur reduc-
ing gear flange bearings
Х
Tighten adjusting nut to a torque of
18...20 kgf
•m, then, back it off
through 15 to 20°. Prick-punch the
nut in two slots of the flange.
19
Operation of diesel-engine start-
up interlock switch
Х
DO NOT start the diesel-engine
with engaged gear.
Check the level and top up, as re-
quired:
20
coolant in the radiator
х
50-60 mm below the top edge of
the filler throat.
Check the oil level and top up, as
required:
21
in diesel-engine crankcase
х
Up to top mark on the oil dipstick.
22
in transmission housings
х
Up to top mark on the oil gauge.
23
in the hydraulic steering booster
casing
х
Up to top mark on the oil gauge.
24
in FDA housing, FDA wheel-hub
reducing gear casings
х
Up to the level of inspection
holes.
in upper bevel pairs (FDA with
bevel wheel reducing gearings)
х
Up to the level of inspection filler
holes.
in the intermediate bearing sup-
port housing
х
Up to the level of inspection hole.
in rear axle wheel-hub reducing
gearings (tractor Belarus-82
Р)
х
Up to the level of inspection
holes.
26
in the hydraulic hitch linkage tank
х
Up to mark
“П” (Full) on oil
measuring rule
27
Change oil in diesel-engine crank-
case, drain oil from the fuel pump
body
х
Drain oil from a warmed-up die-
sel-engine, fill in fresh oil up to
the top mark on the oil dipstick.
29
Replace filtering element in the fuel
fine filter
Х
As a preliminary, drain sediment
from the filter bowl.
30
Replace filtering element in the hy-
draulic system oil tank (tractors
equipped with a unitized cab)
х
Lubricate:
31
clutch release bearing
х
4-6 jerks of the grease gun
нагнетаний шприцем
32
fore axle steering knuckle bush-
ing
х
10-12 jerks of the grease gun
33
HSCU hydraulic cylinder joints
х
Until lubricant is squeezed out
from gaps.
34
RHL right-hand drop link pinion
Х
3-4 jerks of the grease gun
35
rear hitch linkage shat bushings
Until lubricant is squeezed out
from gaps.
Every other MS-1.
