Section 6. Operating and Adjusting Regulations
Belarus 80.1/80.2/82.1/82.2/82
Р — Operation and Service Manual
43
6.4. GETTING THE TRACTOR MOVING
FROM
REST
AND
RUNNING
STRAIGHT
To move off the tractor, proceed as de-
scribed below:
а) set minimum r.p.m. of the diesel-
engine crankshaft;
b) press down the clutch pedal, allow
some instants to elapse for the clutch
rotating parts to stop, and, smoothly
and without kicks, upshift to a required
gear according to the shift pattern dia-
gram located on the right-hand wall of
the cab;
c) release the parking brake; release
smoothly the clutch pedal, with a sim-
ultaneous increase in diesel-engine
rotational speed by a gradual push-
down on the accelerator pedal.
IMPORTANT!
When changing from for-
ward to reverse, change gears only with
the tractor completely stopped. DO NOT
use the clutch pedal as a footrest, since it
will cause slipping of the clutch, its over-
heating and premature wear or possible
failure.
Enter tight turns at low speeds, without
load, only. When in a sharp turn, light brak-
ing of a respective wheel is admissible.
Before operation, depending on condi-
tions for the work to be done, shift the
transfer box control lever 41 (see Fig. 3b)
(tractors with front driving axles) to its
middle position
— i.e. «Automatic Front
Driving Axle Engagement»; or in its ex-
treme forward position, i.e. «Front Driv-
ing Axle Disengaged»
— when on trans-
portation missions, on hard-surface
roads; or to its extreme backward posi-
tion
— i.e. «Front Driving Axle Forced
Engagement»
— for continuous opera-
tions on light and moist soils, for a short
time to overcome a high traction force,
when clearing road obstacles, taking off
in forward and backward.
Fig. 15. Reverse-reducing gear controls
6.5. HINTS ON REVERSE-REDUCING
GEAR CONTROL
The reverse-reducing gear change-over
lever (32
а), see Fig. 15, has the following
positions:
«Reverse (running)» (the reverser en-
gaged)
— its extreme backward position;
«Forward (running)» (the reverser disen-
gaged)
— its extreme forward position.
To change the direction of tractor move-
ment to the reverse, proceed as follows:
1. Press down the clutch pedal;
2. Without disengagement of the select-
ed speed and of the reverse-reducing
gear, stop the tractor; apply brakes, if
necessary, for the purpose;
3. Keeping the clutch pedal pushed
down, change the reverse-reducing
lever from the «Forward» to «Re-
verse», or vice versa;
4. Smoothly release the clutch pedal.
Important!
Shift the reverse-reducer
lever with the depressed clutch pedal
and the tractor at standstill, only.
ATTENTION!
DO NOT leave the re-
verse-reducer lever in a position in-
between the «Forward» and «Re-
verse».
