Belarus 80.1/80.2/82.1/82.2/82
Р — Operation and Service Manual
Section 3. Safety Requirements
19
3.4.6. When operating the tractor with
the rear P.T.O. shaft not in use,
set the drive stem and the con-
trol lever in the neutral and the
disengaged positions, respec-
tively
3.4.7. With a hauling device installed,
DO NOT use the rear hitch link-
age outfit. Lock the
СА-1А auto-
matic coupler dog by means of a
spring split cotter.
3.4.8. With a P.T.O.-driven machine
detached from the tractor, re-
move the universal-joint shaft
and close the P.T.O. tail-piece
with the hood.
3.4.9. Under no circumstances drop
implements by setting the dis-
tributor lever or the draft control
arm into the position "Forced
Drop".
3.4.10. Before starting the diesel engine,
throw the GB shift lever to its ex-
treme left-hand position. Check
to see that the tractor, under it,
as well as between the tractor
and the implement attached and
the area around it are clear of
people during the start-up.
3.4.11. Before getting the tractor mov-
ing, make sure that the reserve
parking brake is disengaged, ap-
ply an audible signal and start
moving smoothly. When on haul-
ing jobs, be sure to use the sear
belts (to be supplied on request).
3.4.12. Whist coupling to the tractor or
mounting
an
farm
ma-
chines/implements, the coupler
should be at a safe distance, un-
til a complete standstill of the
tractor. Coupling (mounting) pro-
cedure shall be initiated only by
the operator’s signal.
3.4.13. Shift gears with the clutch fully
disengaged and at a low rota-
tional speed of the diesel-engine
crankshaft, only.
3.4.14. If a fault is detected, stop the
tractor immediately and remove
the fault.
3.4.15. With the tractor combined with
farm machines and implements,
be sure to comply, in addition,
with the safety requirements for
using these machines/ imple-
ments.
3.4.16. When moving to another field
with the implements raised in
transport position, make use of
the rear hitch linkage locking
mechanism.
3.4.17. A mounted machine/implement
shall only be lowered to the
working position after the aggre-
gate has completed the turn, and
raised before the turn is made.
CAUTION!
To avoid damage or breakage of the
rear hitch linkage system, DO NOT
turn the tractor aggregate if the tools of
the attached implement are buried into
the soil.
3.4.18. When tractor-mounted aggregates
are running in a column, intervals
between them must be as least 30
m.
3.4.19. When operating a tractor Belarus
82
Р, before entering a check plot
flooded with water, first shift the
transfer box control rod rest to
the «P.T.O. Forced Engage-
ment» position, to ensure safe
descent across the slope.
3.4.20. When running the tractor in the
dark, make use of operable and
switched ON illumination devic-
es.
3.4.21. Cleaning, lubrication and repair
jobs on the tractor should only be
initiated with the diesel-engine
completely stopped and the
P.T.O fully disengaged.
