Section 6. Operating and Adjusting Regulations
Belarus 80.1/80.2/82.1/82.2/82
Р — Operation and Service Manual
43
Front Wheeltrack of Tractors «Bela-
rus» 82.1, Equipped with Hypoid Bev-
el Reducing Gears
, is steplessly adjust-
able by a screw mechanism incorporated
in the front axle housings (see Fig. 17)
within the three intervals (see Fig. 18), as
follows: 1350-1500 mm, 1500-1600 mm,
1600-1800 mm.
To change to the required wheeltrack width,
set the position of the wheel rim relative to
the disk, as shown in Fig.18.
On wheels with a constant disk offset,
the wheeltrack is steplessly adjustable
within the 1400...1700 mm interval.
To change the wheeltrack, jack up the trac-
tor front end (or the front wheels one by
one) until there is a clearance between the
wheels and the ground; the rear wheels
should be held braked; then (see Fig. 17):
а) undo bolts and remove the cover (2);
б) release wedges (3) of the axle shaft
housings by loosening nuts, so that
the bevel gearing pair housing could
be shifted freely.
By turning the adjusting screw (1) with
a wrench, shift the hub drive reducing
gear assemblies within the front axle
housings to obtain the required wheel-
track within the above-mentioned in-
tervals. Rotation of the adjusting
screw should be accompanied by a
change in the steering rod length. Af-
ter a change of the wheeltrack, always
adjust the front wheel toe-in.
Fig.16.
Fig.17.
Fig. 18. Diagram of positioning tractor front wheels with hypoid reducing gears to different wheeltracks
(except for Belarus 82
Р).
In Figure:
1350-1500 mm; Over 1500 to 1600 mm; Over 1600 to 1800 mm.
