Section G. Maintenance Belarus– 510/512 Operating manual
101
Operation 34. Steering rod joints
When the engine is running, turn the
steering wheel in both direction to check
free travel and plays in the joints (1) of
the steering rod (4).
If there are any plays in the joints, pro-
ceed as follows:
• remove the lock wire (3);
• tighten up the threaded plugs (2);
• lock the plugs with the wire (3).
NOTE:
If plays in in the joints cannot
be eliminated by tightening the thread-
ed plugs, disassemble the joint and
replace worn-out parts.
Operation 35. Lubricating RHL right an-
gle brace bearing
Lubricate the adjustment mechanism of
the right angle brace through the pres-
sure lubricator (one point of greasing)
using a gun. Make 4…6 injections with
the gun. The Litol-24 grease must be
used.
Operation 36. Lubricating bushings of
RHL pivoting shaft
Apply grease using a gun through the
pressure lubricators in the mounted at-
tachment holder until grease appears
from the gaps. The Litol-24 grease must
be used.
Operation 37. Outside bolted connec-
tions
Check and tighten, if necessary, the crit-
ical bolted connections:
• front and rear wheel nuts and rear
wheel hub bolts;
• front beam — semi-frame side mem-
bers;
• half-frame side members – clutch
casing;
• HDC plate fastening;
• diesel engine — clutch casing;
• clutch casing — gearbox casing;
gearbox casing — rear axle casing;
rear axle casing — RHL and HDC
holders;
front and rear cab supports, holders
and pins of the steering hydraulic cyl-
inder;
rear
axle
casing
—
semi-axle
sleeves;
FDA casing - sleeves — wheel re-
ducing gears;
