Section E. Unitizing Belarus-510/512 — Operating manual
49
Attach machines (implements) to the trac-
tor also using the automatic coupling
СА
-1,
connected to the hitch linkage of the tractor
in three points (two rear joints of the lower
rods and the rear joint of the upper rod).
To prevent spontaneous disconnection of
the machine from the tractor, fix the latch of
the automatic coupling with a spring catch
pin.
Limit (telescopic) rods (1)
The rods are used to limit side oscillation of
the suspension lower rods both in the
transportation, and in the working position.
This is especially necessary when working
on slopes, close to ditches, walls etc.
The back end of the rod is connected to
the lower rod, and the front end is con-
nected to the bracket in one of the four
positions depending on the job.
• Position 1. The rods prevent side oscil-
lation of the implement in the transporta-
tion position.
• Position 2. The rods prevent side oscilla-
tion of the implement both in the trans-
portation and in working positions.
IMPORTANT!
Use the positions 3 and 4
only when installing the lower rods to ad-
ditional suspension axles (upper axles).
• Position 3. The rods prevent side oscil-
lation of the implement in the transpor-
tation position.
• Position 4. The rods prevent side oscil-
lation of the implement both in the
transportation and in working positions.
ATTENTION!
The rods must be in-
stalled only to the bracket holes that
are second from the bottom (position 2)
to prevent damage to the rods.
ATTENTION!
The rods must be in-
stalled only to the bracket holes that
are second from the bottom (position 2)
to prevent damage to the rods.
