Page
39
Environmental Sensors
Individual Sensors
All Sensors
For configuration of all sensors of selected type in system with a
single user-supplied value.
1...Contact
2...Temperature
3...Humidity
4...Air Flow
Enter Request :1
Environmental Sensor Configuration Menu
Sel M/P Identifier
1 2/1 MMP10
2 All Sensors
Enter Request :1
Sel Type Name Hi/En Lo/En St/En
1 Contact External Sensor1 N/A N/A Ds
2 Temperature External Sensor2 0/Ds 0/Ds N/A
Enter Request :2
RPC/RPS External Environmental Sensor Configuration Menu
Sensor Number: 2 Name: External Sensor2 Type: Temperature
1...High Threshold (tenths of meas. unit): 0
2...High Threshold Trap Enable: Disabled
3...Low Threshold (tenths of meas. unit): 0
4...Low Threshold Trap Enable: Disabled
Enter Request :1
RPC/RPS External Environmental Sensor Configuration Menu
Sensor Number: All Name: all RPCs/RPSs
Type: Temperature/Humidity/Air Flow
1...High Threshold (tenths of meas. unit): NP
2...High Threshold Trap Enable: NP
3...Low Threshold (tenths of meas. unit): NP
4...Low Threshold Trap Enable: NP
Enter Request :
Enter threshold value in tenths of unit measurement (degrees,%%,etc.):
Select 1),
to change the limits of
individual probes
Second line identifies the probe name
and type. Option 1 and 3 sets the
temperature levels to the tenth of a
degree. Option 2 and 4 enable the
SNMP traps to be sent if the
corresponding threshold had been
exceeded
Select 2),
to set parameters for the
different probe types. This feature is
useful for standardization and the
probe type is known.
Environmental Sensor Configuration Menu
Sel M/P Identifier
1 2/1 MMP10
2 All Sensors
Enter Request :2
Option 1 and 3 sets the
temperature levels to the tenth of a
degree. Option 2 and 4 enable the
SNMP traps to be sent if the
corresponding threshold had been
exceeded.
NOTE:
NP = No Probe detected.
NOTE:
The type ‘Contact’ signifies
the unit does not recognize or
detect a probe, but still be able to
send SNMP Traps.
Select 5),
to change the alarm limits for the Environmental probes:
If the unit does not have a sensor probe connected, the unit will display the following.
None of the installed devices support this option (no temperature probes installed).
Strike ENTER to continue
Select either 1 or 2 (Sel) probe.
(Hi/En) = Hi limit Enabled, (Lo/En) =
Low limit Enabled, (St/En) = Sensor
Trap enable
