Page
5
COMPLIANCE
STANDARD
CONNECTION
DESCRIPTION
EIA-232 Serial Connection
10/100 Base-T Network Port Connection
BayTech units are in accordance with the general requirements of
Standard for Information
Technology Equipment
(ETL listed, conforms to ANSI/UL 60950-1 2
nd
Edition and CAN/CSA C22.2
No. 60950-00. CE conforms to IEC 60950.)
Equipment installations are to be in accordance with the
Canadian Electrical Code, Part I, CSA C22.1-02; General Requirements – Canadian Electrical, Part
II, CSA C22.2 No 0-M91; the National Electrical Code, NFPA 70-2005; and the National Electrical
Safety Code, NFPA, IEEE C2-2002.
We welcome any comments you may have about our products, and we hope that you will continue to
look to BayTech for your remote management needs.
BayTech's Modular Series unit provides a Serial EIA232 interface that controls user access and outlet
controls to the power strip.
CAUTION:
All power should be removed from the BayTech unit prior to removing or installing
cables and /or adapters.
ATTENTION:
Tout pouvoir doit être retiré de l'unité BayTech avant de retirer ou d'installer des
câbles et / ou des adaptateurs
The Module has an RJ-45 port which uses an 8-pin crossed modular cable to connect to a local EIA-
232 device such as a computer terminal or external modem. Most serial computers do not have RJ-45
connections; therefore an adapter is provided with this unit to convert from a DE-9 connector to an RJ-
45 connector (Bay Tech Part No. 9FRJ45PC-4). An adapter to convert from a DB-25 connector to an
RJ-45 connector is also available from Bay Tech, upon request (Bay Tech Part No. 25FRJ45PC-4).
The 8-pin crossed modular cable is configured to operate with these adapters.
NOTE:
Custom cables are available to connect a device to this unit’s serial port. These custom
cables are one-way cables labeled with Baytech on one end and a device name on the other end.
REMARQUE:
les câbles sur mesure sont disponibles pour connecter un périphérique au port
série de cet appareil. Ces câbles sont des câbles de commande à sens unique marqué par
Baytech à une extrémité et un nom de périphérique à l'autre extrémité.
Using a straight 10/100 Base-T cable, connect the RJ-45 port labeled ETHERNET on the HOST
module to an RJ-45 port on the network hub. The LINK (link integrity) LED, located on the front panel of
the HOST, illuminates when a good connection is established between the HOST and the hub.
The Ethernet processors is flash upgradable via Ethernet port
