Barudan BEXS, Instruction Manual

Page: 149 / 233

１１‐４
2. MC List
Icons Parameter Function/Action
Range Of
Values
Default
Value
1
Borer 1
Switches off the thread break detector of a needle
fitted with a boring device. Enter the number of
the needle that has the borer. Set to 0 if a boring
device is not in use.
0 – 15
[Needles]
0
2
Trim Jumps
Controls the number of jump stitches above with
the thread trimmer will cut the thread. If set at
3, when the M/C reads three or more consecutive
jump stitches, it will stop and trim the thread. If
set at 0, the thread will not be trimmed at any
jump stitch.
0 – 9
[Stitches]
2
3
Lock Stitch
On starting up after a trim, the machine does lock
stitches in the following methods:
1,11 = Split stitch – splits first stitch into two
stitches.
* 2,12 = Small triangle–sews a small triangle.
* 3,13 = Back stitch = splits first stitch into two
stitches then backs over the same two
stitches.
Settings 11 –13 should be used if stitches less than
0.5 mm are needed at the start sewing.
4 = to start sewing as the stitching data indicates
(It doesn’t lock stitches after a trim.
(For DS, V1.70 R03
～
)
14 = to start sewing where trimming was
executed and sew as the data (It doesn’t lock
stitches after a trim. (For DS V1.70 R03
～
)
1 - 4
and
11-14
1
4
Clamp Type
1 = Double clamp action (recommended for thick
fabric): The clamp opens (at 295 degrees, it
depends on Clamp Off Angle of MSU1) at first
stitch before the needle penetrates garment
and closes at dead bottom (0 degree).
2 = Single Clamp action (recommended for thin
fabric): The clamp opens at second stitch when
sewing starts.
3 = Clamp and fork action (recommended when a
shorter tail is required at the start of sewing):
The clamp opens at first stitch before the
needle penetrates the garment.
1 - 3 1
5
Slow up Count
Controls the machine speed at the start of sewing to 180
RPM for these specified amount of stitches, then ramps up
to the normal sewing speed.
3 – 15
[Stitches]
3