Barudan BEXS, Instruction Manual

Page: 212 / 233

Adjusting the Take-up Spring
1.
Loosen
the take-up spring by inserting
a screwdriver into the post and turn
counterclockwise
, until the take-up
spring has moved off of the detection
bracket.. Then, turn the screwdriver
clockwise until the take-up spring
touches the detection bracket. Turn
approximately ¼ of a turn more so that
the slot in the post is at approximately
11:00.
Sewing Preparation
Using the proper size hoop when embroidering finished goods ensures the best results. Before
hooping, use Float, the H and V values or Perimeter Trace to determine the pattern size and
choose a hoop slightly larger than the pattern. It is recommended to leave at least a 1/2"
clearance around the pattern. The garment must be hooped straight and tight so the
embroidery appears straight. It is best to use a framing board system which holds the hoop
stationary so you can use both hands when straightening and smoothing the fabric.
Positioning the Design on the Garment
The placement of a design on a garment is subject to many variables, such as customer
preference, size and style of the garment, size and style of the design and the degree of
difficulty in working with the garment. We have assembled some guidelines for placing
designs on some popular garments. These measurements are approximate and refer to the
center point of the entire design.
NOTE: Monograms and names should be placed on the left front unless
otherwise specified. For children’s clothing, these measurements should be
scaled down.
1-24
X
Series Mechanical Guide