Barudan BEXS, Instruction Manual

Page: 184 / 233

１３‐１１
Message
(Code)
Description Trouble shooting
D32
Stopped for Sub End Code
Message that Roll to Roll feature is turned On, and
machine stopped due to Sub End code in design data.
D33
Power Interrupt Error
A power interruption to the machine has occurred.
Power down the machine, then back On to re
-
set. If
you continue to get this error, check for electrical
power problems to machine. Try another known good
power outlet, or another circuit that’s not being used
by other equipment.
D34
Stopped by Light Curtain Optional light curtain activated. Something is
blocking the light beam or light beam is not working
properly. Check light curtain.
D35
Lubrication Error
Optional Device. Check Lubrication device.
D36
Stopped for Bobbin
Counter
When Bobbin counter feature is activated, machine
stops, trims the bobbin and gives this message to let
you know why it stopped. Change your bobbin, and
start machine to reset.
D37
Sequin Device Error
Check that Sequin Driver box is turned on. Call
tech support
D38
Chenille Driver Error Turn off the machine and reboot. Make sure the
Chenille Driver box is turned On. If the same error
message displays again, check the wiring to the
Needle Bar rotation motor. Otherwise motor may be
faulty or jammed. Call Tech support.
D39
Looper Motor Error
Turn off the machine and reboot. If still a problem,
turn the Looper motor shaft manually until the (top)
shaft sensor turns On and retry. Call Tech support
for more help.
D40
Chenille Thread Clamp
Motor Error
Turn off the machine and reboot. If still a problem,
turn the tension release motor shaft manually until
the shaft sensor turns On and retry. Call Tech
support for more help.