Barudan BEXS, Instruction Manual

Page: 153 / 233

１１‐８
Icon Parameter Function/Action
Range Of
Value
Default
Value
18
Appliqué
Sets pressure foot height when the Appliqué
command is executed. Parameter is set in degrees,
referring to the pressure foot height as shown on
the degree wheel.
*This method may be used for verification of start
position.
60 – 120
[degree]
80
19
T - Break
The m/c is designed to stop automatically when
top thread is broken. Normal value is 3, meaning
the m/c requires three consecutive thread break
detections before stopping.
*If the m/c does not stop even though a thread
break occurs, changing the value to 2 may correct
the problem.
*If the m/c stops without a thread break, changing
the value to 4 or 5 may correct the problem.
1 – 9
[stitch]
3
20
0 admit
Determines the number of 0 data stitches allowed
when the pattern is read into memory.
0 = deletes all 0 data, letting none into the
pattern in memory. Setting at 1 allows one 0
data stitch, etc. up to 8.
9 = Allows all 0 data stitches into memory.
*All 0 data stitches will be deleted automatically
after thread is trimmed, even if set to 9.
0 - 9 0
21
Combine Data
Determines the smallest stitch length allowed
when pattern is read into memory. Stitches
smaller than allowed length are combined into
larger stitches. E.g..
0 = No allowance
1 = less than 0.1mm stitches are combined into
larger stitches.
2 = less than 0.2mm stitches are combined into
larger stitches.
5 = less than 0.5mm stitches are combined into
larger stitches.
* Less than 0.4mm stitches will be combined into
larger stitches automatically after the thread is
trimmed.
0 - 9 0